Advanced Power Drives
  • APD Documentation and FAQs
  • Product Notices
    • 04/01/2023 - Overvoltage Issue
  • Downloads
    • Configurator
    • Flashing Tool
    • Firmware
      • UHV and HV Pro Firmware
      • F Series Production Firmware
      • F Series [BETA] Firmware
    • 3D Model Downloads
  • Product Guides
    • UHV ESC
      • Quick Start Guide
      • Advanced Setup
      • UHV Configuration Options
      • UART Telemetry Output
      • Troubleshooting
      • Datasheets
      • Firmware Installation
    • HV Pro ESC
      • Quick Start Guide
      • Advanced Setup
      • HV Pro Configuration Options
      • UART Telemetry Output
      • Troubleshooting
      • Datasheets
      • Firmware Installation
    • F Series ESC
      • Physical features
      • Quick Start Guide
      • Advanced Setup
      • F Series Configuration Options
      • Troubleshooting
      • Datasheets
      • Production Firmware Install
      • Legacy Firmware Install
    • Power Distribution
      • Datasheets
    • Help
    • Warranty
Powered by GitBook
On this page
  1. Product Guides
  2. UHV ESC

Firmware Installation

Installation of firmware to UHV and HV Pro units.

PreviousDatasheetsNextHV Pro ESC

Last updated 1 year ago

To install firmware on the HV Pro and UHV units, the APD configuration tool and STM DFUSE utility are required.

STM DFUSE:

When using Windows 10, the default drivers can be used once DFUSE is installed (located at Program Files (x86)\STMicroelectronics\Software\DfuSe v3.0.6\Bin\Driver\Win10). In most cases, manual driver installation is not required.

If the ESC is placed into DFU mode, and DFUSE is not picking it up, the driver is incorrect. The current STM driver should be uninstalled, and the DFU driver should be installed from the location mentioned. The document below outlines the process of replacing the driver.

Older Firmware Upgrades

When using the APD configuration tool, upon connection older firmware versions will return the following pop-up to indicate an update is available:

If this pop-up occurs for a specific ESC, a firmware update is required to use this tool. Click OK and follow the following instructions. If the ESC connects successfully with no pop-up, skip to the next section.

  1. To flash the firmware, open DFUSE (Sometimes called DFuSeDemo), and there will be an STM device in DFU picked up. If no device appears, check the drivers (Windows defaults are recommended).

  2. Under the upgrade section (Button 1), choose the firmware file that was downloaded.

  3. Press Upgrade (Button 2) to begin the install.

  4. Once the ESC has completed the update, disconnect it from the PC and reconnect it.

  5. Connect to the configuration tool (if the tool's port is set to Auto, it will pick up any new COM port that connects while it is running).

  6. Configure as required. Make sure logs are deleted when an update has completed, as newer firmware may contain changes resulting in strange data outputs.

Update Firmware in Config Tool

If the ESC connects to the configuration tool with no pop-ups, this indicates version 2 firmware is installed to the unit. Under the Firmware tab, versions can be selected and installed as required.

Download
112KB
APD-DRV-ISN-001-1.pdf
pdf
Driver replacement instructions for DFU.
Pop-up when attempting connection using v2 config tool and older firmware